Peculiarities of tool material wear at polymeric composite blank cutting

Yuriy Zubarev; Alexsandr Priyomyshev

doi:doi:10.30987/article_5b3135277d48c6.67970085

UDC 67

Peculiarities of tool material wear at polymeric composite blank cutting

Published в Science intensive technologies in mechanical engineering · Volume 2018, Issue 7, 2018 · Pages 27–31 · Rubrics: SCIENCE INTENSIVE TECHNOLOGIES OF NONMETALLIC PARTS PRODUCTION

DOI 10.30987/article_5b3135277d48c6.67970085

Received: 25.06.2018 Accepted: 14.07.2018 Published: 14.07.2018 Language of publication: RUS

Authors

Yuriy Zubarev ¹ · Alexsandr Priyomyshev ²

1 Saint-Petersburg State Marine Technical University (professor)
Sankt-Peterburg, Russian Federation

2 Peter the Great Saint-Petersburg Polytechnic University (docent)
Sankt-Peterburg, St. Petersburg, Russian Federation

ABSTRACT

Tool materials used for polymeric composite blank machining, kinds of tool material wear arising at machining these blanks, and also the impact of technological parameters upon tool wear are considered. The obtained results allow estimating the potentialities of physical models at polymeric composite blanks cutting.

KEYWORDS

wear polymeric composites abrasive wear scuffing macrodestructions microchips

Information References

Authors:

1. Saint-Petersburg State Marine Technical University (professor)

Sankt-Peterburg, Russian Federation

2. Peter the Great Saint-Petersburg Polytechnic University (docent)

Sankt-Peterburg, St. Petersburg, Russian Federation

Type:

Article

Pages:

from 27 to 31

Status:

Published

Subject area:

UDC 67

Language:

Russian, English

Keywords:

wear, polymeric composites, abrasive wear, scuffing, macrodestructions, microchips

References

1. Zubarev, Yu.M. Modern Tool Materials. - S-Bb.: “Lan” Publishing House, 2014. - pp. 304.

2. Zubarev, Yu.M. Priyomyshev, A.V. Innovation technol-ogies of polymeric composite machining in mechanical engi-neering // Science Intensive Technologies in Mechanical Engi-neering. - 2017. - No.8 (74) - pp. 36-42.

3. Zubarev, Yu.M. Priyomyshev, A.V. Zaostrovsky, A.S. Polymeric Materials in Mechanical Engineering and Technol-ogies of Their Machining / under the editorship of Yu.M. Zu-barev. - S-Pb.: Publishing House of Polytechnic University, 2017. - pp. 172.

Peculiarities of tool material wear at polymeric composite blank cutting

Confirmation

Регистрация