Grinding efficiency increase through physical – chemical processes control in “tool-billet” contact

Boris Brzhozovskiy; Andrey Slavin

doi:doi:10.12737/18711

Grinding efficiency increase through physical – chemical processes control in “tool-billet” contact

Published в Science intensive technologies in mechanical engineering · Volume 1, Issue 5, 2016 · Pages 24–29 · Rubrics: SCIENCE INTENSIVE TECHNOLOGIES OF MACHINING (archived)

DOI 10.12737/18711

Received: 01.04.2016 Accepted: 01.04.2016 Published: 01.04.2016 Language of publication: RUS

Authors

Boris Brzhozovskiy ¹ · Andrey Slavin ²

1 Yuri Gagarin State Technical University of Saratov (kafedra "Tehnologiya mashinostroeniya", professor)
Saratov, Saratov, Russian Federation

2 All-Russian Research Institute of Aircraft Materials (ispytatel'nyy centr, nachal'nik)
Himki, Moskovskoy oblasti, Moscow, Russian Federation

ABSTRACT

The ways to increase grinding effectiveness by means of physical –chemical process control in a “disk-billet” contact are considered. The impact of physical-chemical properties of cutting emulsion (CE) upon grinding basic indices is shown. The hierarchical threshold structure of a grinding process based on a neuronet model allowing automating the machining techniques designing is offered.

KEYWORDS

grinding cutting emulsion cutting power wear.

Information Text References

Authors:

1. Yuri Gagarin State Technical University of Saratov (kafedra "Tehnologiya mashinostroeniya", professor)

Saratov, Saratov, Russian Federation

2. All-Russian Research Institute of Aircraft Materials (ispytatel'nyy centr, nachal'nik)

Himki, Moskovskoy oblasti, Moscow, Russian Federation

Type:

Article

Pages:

from 24 to 29

Status:

Published

Language:

Russian, English

Keywords:

grinding, cutting emulsion, cutting power, wear.

Text

Text (PDF): Read Download

References

1. Bezyazychny V.F. Influence of surface layer quality after machining upon machinery performance attributes // Surface Engineering: Supplement to Journal: Reference Book. Engineering Journal. 2001. № 1. pp. 9 - 17.

2. Suslov A.G. Parameter State Technological Support for Part Surface Layer. М.: Mechanical Engineering, 1987.

3. Yankin I.N., Brzhezovsky B.M., Brovko M.B. Grinding quality assurance based on dynamic interaction peculiarities of tool and produce subsystems / // Proceedings of the 7-th Inter. Scientific -tech. Conf. ”DTS-2004”. Saratov, 2004. pp. 372 - 375.

4. Brzhezovsky B.M., Slavin А.V. Cutting emulsion influence upon chip forming at metal grinding // Bulletin of State Technical University of Saratov. 2011. № 4 (60). Issue 2. pp. 138 - 142.

5. Slavin А.V., Shumyacher V.М. Mechanical - chemical processes of abrasive tool and billet at metal grinding //Engineering Techniques. 2008. № 1. pp. 29 - 32.

6. Filimonov L.N. High-speed Grinding. L.: Mechanical Engineering, 1979. pp. 248.

7. Slavin А.V. Threshold hierarchical system as means for factor analysis of abrasion processes // Bulletin of the State Technical University of Saratov. 2013. № 1 (69). pp. 116 - 118.

Grinding efficiency increase through physical – chemical processes control in “tool-billet” contact

Confirmation

Регистрация